With a 40V rated integrated switch FET, the SGM3726 is a boost converter that drives up to 10 LEDs in series. The boost converter runs at a 1.2MHz fixed switching frequency with 1.1A switch current limit, and allows for the use of a high brightness LED in general lighting.
The default white LED current is set with the external sensor resistor RSET, and the feedback voltage is regulated to 200mV, as shown in the typical application. During the operation, the LED current can be controlled using PWM signal through the CTRL pin, the pulse width modulation (PWM) signal determines the feedback reference voltage. In PWM mode, the SGM3726 does not burst the LED current; therefore, it does not generate audible noises on the output capacitor. For maximum protection, the device features integrated open LED protection that disables the SGM3726 to prevent the output voltage from exceeding the IC’s absolute maximum voltage ratings during open LED conditions.
The SGM3726 is available in Green TDFN-2×2-6L and TSOT-23-6 packages. It operates over an ambient temperature range of -40℃ to +85℃.
•
Input Voltage Range: 3V to 20V
• 38V Open LED Protection for 10 LEDs
•
200mV Reference Voltage
• 500kΩ Pull-Low Resistor on CTRL Pin
• 1.1A
Switch FET with 1.2MHz Switching Frequency
• PWM Brightness Control
• 1kHz
to 100kHz PWM Dimming Frequency Range
• Soft-Start Function
• Up to 90%
Efficiency
• -40℃ to +85℃ Operating Temperature Range
• Available in Green TDFN-2×2-6L and
TSOT-23-6 Packages
High
Brightness LED Lighting
White LED Backlighting for Media Form Factor
Display
